ADVICE FOR SAFETY
Gas connectionsElectrical connections
" Before installation ensure that the localThis cooker is designed to be connected to a
distribution conditions (gas type and230-240V 50Hz AC electrical supply.
pressure) and the pre-setting of theBefore switching on, make sure the electricity
appliance are consistent.supply voltage is the same as that indicated on
" This appliance must be installed only in athe rating plate.
room with good ventilation.
" This appliance must not connected to aAny electrical work required to install
chimney. It has to be installed and connectedthis cooker should be carried out by a
in accordance with the rules in force. Specialqualified electrician or competent person, in
attention should be paid to the applicableaccordance with the current regulations.
disposal concerning ventilation.
This cooker must be earthed.
" The adjacent furniture panels have to be heat
proof or protected by such material.
Check on the rating plate the value for the total
" The adjusting conditions of this appliance are
connection power for establishing the fuse
mentioned on the rating plate.
power.
Connection to gas supply.
Fuse capacity: max 5 A
Check that the gas flow and the diameter of the
supply pipe is sufficient to supply all the
If the supply cord is damaged, it must
appliances of the installation.
be replaced by the manufacturer or its
" Check that all connections are tight.
service agent or a similarly qualified
" Install an accessible and visible gas tap to
person in order to avoid a hazard.
isolate the appliance.
Ensure that the supply cable does not
come into contact with any part of the
The manufacturer declines any
hatched area shown in the diagram.
responsibility for possible damages resulting
from an installation which doesn't comply
with current legislation.
- Installation of flues and ventilation for
connection
gas appliances of rated input not
stndrd of flexible
exceeding 60 kW (1, 2 and 3 family
hose
gases) - Part 2 Specification for
installation of ventilation for gas
appliances - BS 5440;
- Gas burning appliances - Part 3
power
Domestic cooking appliances burning
cord
gas - BS 5386;
- Specification for installation of low
pressure gas pipe work of up to 20mm
nd
(R1) in domestic premises (2 familyBefore connecting check that:
gas) - BS 6891;
" The plug used for connection is easily
- Pipe threads for tubes and fittings where
accessible when the appliance is installed.
pressure-tight joints are made on the
threads (metric dimensions) - BS 21:
1985;
- Flexible hoses, end fittings and sockets
for gas burning appliances - BS 669;
- Installation of domestic gas cooking
stndrd
appliances (1, 2 and 3 family gases) -
BS 6172: 1990;
18 |
ACEC
